Saturday, November 23, 2013

Fuel Cell

For this six weeks I chose to build a outstrip astound go off booth automobile. This is a part of my graduation travail for senior year. I chose this because my faculty advisor teaches the class I worked on it in. I went by a process to take on sex this elevator car but it was very interesting, and I well-educated a lot from it. I had to browse the web in chase of a way to make a scale mannikin give notice cell car. After many eld of seek I stumbled across a process of constructing whiz through the use of an RC car and a small fuel cell. I read over the details and ordered the split I needed to build the car. The parts came in laterwards a few days and I began to build the car. First, I had to tack to stand byher the fuel cell. I followed the steps from the breeding Manuel but changed a few things. Instead of imputeing it all to the fuel cell car base I stationed it all on top of the RC car. I could not glue it so I apply some double si ded tape to make accredited nothing ferocious off when the car became operational. Next after everything was attached I had to find a way to connect the fuel cell to the battery choose. I ordered a chip for the car to help do this, but I could not take care out how to connect it so I came up with an alternating(a) way. I sautered a piece of bull wire to the autocratic and negative destinations of the RC cars battery pack.
bestessaycheap.com is a professional essay writing service at which you can buy essays on any topics and disciplines! All custom essays are written by professional writers!
Then I lodge the wires that were connected from the fuel cell into the battery pack so I could keep a constant online of energy rate of flow from the fuel cell to the car so it wou ld be adapted to move. Next I had to sul! ly the fuel for the cell. For this I used distilled war because regular leaping water cannot pass through the cell due to chemicals in it. I filled the gaseous state storage cylinders with the distilled water. I then attached two six-inch lengths of silicon tubing to the cylinders. I plugged one lay off of the heat content cylinder tubing into one of the tube stubs on the pitch-dark terminal side of the fuel cell. I plugged different end of the oxygen cylinder tubing into one...If you want to get a full essay, order it on our website: BestEssayCheap.com

If you want to get a full essay, visit our page: cheap essay

No comments:

Post a Comment